Loading System MkII Technical Data
11
Top Column 4.7
When working at lower heights the Top Column 4.7 locates the anchor point
at 4,7 m above ground level. The Top Column 4.7 will fit into the Base when
the Base is packed and therefore takes up no extra space when storing the
item.
Material: ..................................... Hot dip galvanised/painted steel
Weight: ....................................... 25 kg
Height: ....................................... 1,2 m
SkyReach Adaptor 5.9
When a greater working height is required than the Top Column 4.7 provides,
the SkyReach Adaptor 5.9 will give a total height of 5,9 m from the ground to
the anchor point.
Material: ..................................... Hot dip galvanised/painted steel
Weight: ....................................... 27 kg
Height: ....................................... 2,4 m
SkyReach Anchor
The SkyReach Anchor is designed to be a lightweight product and is easily
foldable for moving and configured to be space-saving when transporting or
storing the item, see Figure 5. To secure both positions (assembled mode and
folded mode) the attached Lock Pin is used.
For lifting SkyReach Anchor by crane there are 2 lifting eyes. For lifting use 2
slings with equal length, each connected to one lifting eye (slings are not
included).
Material: ..................................... Hot dip galvanised/painted steel
Weight: ....................................... 25 kg
Height: ....................................... 3,1 m
Assembled width: ....................... 2,0 m
Packed width: ............................ 0,2 m
NB. Suitable slings are available from Combisafe, order code 100686
To Next Page
Loading...