EasyManua.ls Logo

Comelit UT1010 - Button and Output Configurations; Audio Module Button Functions; Module Button Types; SE and Relay Output Configuration

Comelit UT1010
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN
12
BUTTONS
AUDIO MODULE
• Button: select the button to program, referring to the images
• Function: this option is used to assign a dierent action to each module button
◊ None: no action (default)
◊ Light-me: this option is used to activate the LIGHT-ME function for the selected button
◊ Audio call: when the button is pressed, an audio call is made to the address entered in the “Address”
field (from 1 to 240). The “Number of calls” field also appears, in which you can select the number of
calls to make to the address entered in the “Address” field (System settings or from 1 to 10)
◊ Local output control: when the button is pressed, the output set in the “Output” field is activated (SE
output for the module or Relay output for the module)
◊ Actuator control: when the button is pressed, the actuator with the address entered in the “Address”
field is activated
◊ Control on Ultra bus (UDB): activates the relay on the Module keypad specified in the “Device type”
field (UDB output type: Relay 1 or Relay 2)
OUTPUTS
SE OUTPUT
• Function: select the command which activates the SE output for the audio module
◊ Lock-release: every lock-release command activates the output
◊ Actuator control: every actuator command with the address set in the “Address sent to external unit”
field activates the output
◊ Call sent: every call sent activates the output
• Activation
◊ Local output control (non-editable)
• Local output type
◊ SE (non-editable)
• Enable Tones: a confirmation tone is emitted when the output is activated for the time period set in the
“Activation time (sec.)” field
RELAY OUTPUT
• Function: select the command which activates the Relay output for the audio module
◊ Lock-release: every lock-release command activates the output
◊ Actuator control: every actuator command with the address set in the “Address sent to external unit”
field activates the output
◊ Call sent: every call sent activates the output
BUTTON MODULE TYPE
• Button module type: select the button module model, UT9200 (default) or 3063U
MODULES
• Button: select the button to program, referring to the images
• Function: this option is used to assign a dierent action to each module button
◊ None: no action (default)
◊ Audio call: when the button is pressed, an audio call is made to the address entered in the “Address”
field (from 1 to 240). The “Number of calls” field also appears, in which you can select the number of
calls to make to the address entered in the “Address” field (System settings or from 1 to 10)
◊ Local output control: when the button is pressed, the output set in the “Output” field is activated (SE
output for the module or Relay output for the module)
◊ Actuator control: when the button is pressed, the actuator with the address entered in the “Address”
field is activated
◊ Control on Ultra bus (UDB): activates the relay on the Module keypad specified in the “Device type”
field (UDB output type: Relay 1 or Relay 2)