CommScope OneCell - Figure 4-2 Drop Rail, System Integrator-Provided

Chapter 4 RP5100i installation
4-4 M0303A2 4.5.01 September 2020
D
R
A
F
T
Mounting the Radio Point (RP) above or on the ceiling tile requires the following
hardware provided by the system integrator:
• Drop rail – Eaton B-line BA50A or equivalent, with a static load capacity of at
least 25 lbs without a drop wire, recommended
Figure 4-2. Drop rail, system integrator-provided
Drop rail
Clamp
2 screws