CommScope OneCell - Figure 4-3 Commscope Flown Mount Kit Contents

Chapter 4 RP5100i installation
OneCell
®
Hardware Installation, Release 4.5 4-23
D
R
A
F
T
Figure 4-3. CommScope flown mount kit contents
Mounting the Radio Point (RP) in the flown configuration requires the following
hardware provided by the system integrator:
• Rod, 3/8-inch threaded
• Nut
• Lock nut, nylon
• Flat washers
Octagon
box
Mounting plate for
octagon box with 2
screws
Mounting plate for RP
with 4 screws