Section 3: Onsite Analysis - Measurement Menu
28
Section 3: Onsite Analysis -
Measurement Menu
This section describes the procedures for measuring vibration and
performing onsite analysis.
You will learn to:
• Take frequency domain measurements (spectra)
• Take time domain measurements (waveforms)
• Take demodulation measurements
• Use the tachometer to gather speed, amplitude and phase
data
• Perform time synchronous averaging
• Perform bump tests
• Take run-up and coast-down measurements
• Take cross channel phase measurements
• Store measurements
• Analyze measurements
• Customize the default measurement menus
• Change the on-screen display options of your instrument
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...