EasyManua.ls Logo

Compaq Deskpro 4000 - 2.2 FEATURES; 2.2.1 STANDARD FEATURES

Compaq Deskpro 4000
226 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 2 System Overview
Compaq Deskpro 4000 and 6000 Personal Computers
featuring the Pentium II Processor
First Edition - October 1997
2-2
2.2 FEATURES
This section describes the standard and distinguishing features.
2.2.1 STANDARD FEATURES
The following standard features are included on all models:
Pentium II processor
32-/64-MB unbuffered SDRAM
3.5 inch, 1.44-MB diskette drive
Hard drive fault prediction
Serial interfaces (2)
Parallel interface
Accelerated graphics port (AGP) interface
Universal serial bus interfaces (2)
10/100 MHz (auto-sensing) network interface controller
IrDA interface
Three or four PCI connectors
Three ISA connectors
Compaq Space Saver keyboard w/Windows support
Compaq PS/2-type mouse
APM 1.2 power management support
Smart Cover Lock
Plug ’n Play compatible (with ESCD support)
The supported Intelligent Manageability features are listed below:
Configuration
Management
Asset
Management
Fault
Management
Security
Management
Remote ROM Flash RAM Type Data ECC RAM Fault Prediction Memory Change Alert
Remote Security DMI BIOS SMART II Hard Drive Ownership Tag
Remote Wakeup Asset Tag Monitor Fault Diag. Config. Cntrl. Hardware
Remote Shutdown Sys. Serial # UATA Integrity Log. Setup Password
Replicated Setup Sys. Manuf./Model Proactive Backup Power-On Password
ACPI-Ready Sys. Board Rev. Level Thermal Sensor QuickLock/QuickBlank
Dual-State Power Sw. ROM rev. Diskette Boot Cntrl.
Failsafe Boot Block ROM Hard Drive Type Data Diskette Write Cntrl.
Monitor Type Data I/O Port En/Dis. Cntrl.
Compaq Insight Edition Cable Lock Provision
The Intelligent Manageability features provide support for DMI 2.0, Compaq Insight Manager,
and Management Solutions Partners.

Table of Contents

Related product manuals