Compaq Deskpro AP550 - Page 135

Diagnostic Tools
4-41
Table 4-28
SCSI Test Error Codes
continued
Error Code Description Recommended Action
66XX-24 Media hard error
1. Replace current DATA CD
with different DATA CD.
2. Replace drive.
67XX-24 Media hard error
1. Ensure correct media type
for this tape drive.
2. Replace current tape with
new tape.
3. Replace tape drive.
XXXX-25 Unknown
XXXX-30 Controller timed out Replace the indicated device.
XXXX-31 Unrecoverable error Replace the indicated device.
XXXX-32 Controller/drive disconnected Replace the indicated device.
XXXX-33 Illegal controller command Replace the indicated device.
XXXX-34 Invalid SCSI bus phase Replace the indicated device.
XXXX-35 Invalid SCSI bus phase Replace the indicated device.
XXXX-36 Invalid SCSI bus phase Replace the indicated device.
XXXX-39 Error status from drive Replace the indicated device.
XXXX-40 Target timed out Replace the indicated device.
XXXX-41 SCSI bus stayed busy Replace the indicated device.
XXXX-42 ACK/REQ lines bad Replace the indicated device.
XXXX-43 ACK did not deassert Replace the indicated device.
XXXX-44 Parity error Replace the indicated device.
XXXX-50 Data pins bad Replace the indicated device.
XXXX-51 Data line 7 bad Replace the indicated device.
XXXX-52 MSG, C/D, and/or I/O lines bad Replace the indicated device.
XXXX-53 BSY never went busy Replace the indicated device.
XXXX-54 BSY stayed busy Replace the indicated device.
XXXX-60 Controller CONFIG-1 register bad Replace the indicated device.
XXXX-61 Controller CONFIG-2 register bad Replace the indicated device.
XXXX-65 Media not unloaded Replace the indicated device.
continued