Jumper Option Description
===========================================================================
SW1
---------------------------------------------------------------------------
1 Off SCSI-2 level
2 Off Normal operation
3 On Unit attention enabled
4 On Retry count is unlimited
5 On Parity checking enabled
6 On Initiate SDTR message at power-on and reset
7 On LED lights during operation
8 Off Spin up with Start Unit Command
CNH11
---------------------------------------------------------------------------
1 - 2 Park SCSI address, Unit Select 1
3 - 4 Park SCSI address, Unit Select 2
5 - 6 Park SCSI address, Unit Select 3
7 - 8 On Write protect disabled
9 - 10 Off Reserved
CNH10
---------------------------------------------------------------------------
1 - 2 On Spindle sync terminating resistor power
3 - 4 On SCSI terminating resistor power from IDD
5 - 6 On SCSI terminating resistor power from
TERMPWR
CNH6
---------------------------------------------------------------------------
A0 Off SCSI address, Unit Select 1
A1 Off SCSI address, Unit Select 2
A2 Off SCSI address, Unit Select 3
===========================================================================
To Next Page
Loading...
