1736 - xx Drive monitoring test
failed
---------------------------------------------------------------------------
* ECC = Error Correction Code
===========================================================================
Table 2-10. Tape Drive Test Error Codes
===========================================================================
Error
Code Description Recommended Action
===========================================================================
1900 - xx Tape ID failed The following steps apply to 1900 - xx
through 1906 - xx error codes:
1901 - xx Tape servo write
failed 1. Replace the tape cartridge and
retest.
1902 - xx Tape format failed 2. Check the switch settings on the
adapter board.
1903 - xx Tape drive sensor 3. Check and/or replace the signal
test failed cable and retest.
4. Replace the tape adapter board
1904 - xx Tape BOT/EOT test (if applicable) and retest.
failed 5. Replace the tape drive and retest.
6. Replace the system board and retest.
1905 - xx Tape read test failed
1906 - xx Tape write/read/
compare test failed
===========================================================================
Table 2-11. Video Test Error Codes
===========================================================================
Error
Code Description Recommended Action
===========================================================================
501 - xx Video controller test The following error codes apply to
failed 501 - xx through 516 - xx error codes:
502 - xx Video memory test 1. Replace the monitor and retest.
failed 2. Replace the system board.
503 - xx Video attribute test
failed
504 - xx Video character set
test failed
505 - xx Video 80 x 25 mode
9 x 14 character cell
test failed
506 - xx Video 80 x 25 mode
8 x 8 character cell
test failed
507 - xx Video 40 x 25 mode
test failed
508 - xx Video 320 x 200 mode
color set 0 test