EasyManua.ls Logo

Compaq Prolinea Family - Page 47

Compaq Prolinea Family
197 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Drive not found. Cable could be loose. Check cable
connections.
---------------------------------------------------------------------------
Nonsystem disk message. 1. The system is trying to start from a
diskette that is not bootable. Remove the
diskette from the diskette drive.
2. The system is trying to start from the
hard drive but the hard disk has been
damaged. Insert a bootable diskette into
the diskette drive and restart the
computer with Ctrl+Alt+Del.
3. Diskette boot has been disabled in
Computer Setup. Run Computer Setup and
enable diskette boot.
---------------------------------------------------------------------------
Hard drive operation seems The hard disk files may be fragmented.
slow. At the C:\> prompt, run CHKDSK to check for
problems. If problems exist, run CHKDSK /F
to correct the problems. If a large number
of lost allocation units is found, run the
MS-DOS defragmentation program DEFRAG. See
the MICROSOFT WINDOWS & MS-DOS 6.2 USER'S
GUIDE for more information.
Alternatively, at the C:\> prompt, run
SCANDISK to check for problems. If problems
exist, run SCANDISK/AUTOFIX to correct the
problems. If a large number of lost
allocation units is found, run the MS-DOS
defragmentation program DEFRAG. Type HELP
SCANDISK for more information.
---------------------------------------------------------------------------
Hard drive activity light The hard disk files may be fragmented.
is not on, or stays on At the C:\> prompt, run CHKDSK to check for
without blinking. problems. If problems exist, run CHKDSK /F
to correct the problems. If a large number
of lost allocation units is found, run the
MS-DOS defragmentation program DEFRAG. See
the MICROSOFT WINDOWS & MS-DOS 6.2 USER'S
GUIDE for more information.
Alternatively, at the C:\> prompt, run
SCANDISK to check for problems. If problems
exist, run SCANDISK/AUTOFIX to correct the
problems. If a large number of lost
allocation units is found, run the MS-DOS
defragmentation program DEFRAG. Type HELP
SCANDISK for more information.
===========================================================================
Hardware Installation Problems
This section identifies some quick checks for a hardware problems.
Table 2-20. Solutions for Hardware Installation Problems
===========================================================================
Problem Possible Solutions
===========================================================================
A new device is not 1. When the system advised you of changes to
recognized as part the configuration, they were ignored.

Related product manuals