COMPRION TraceCase - Switching On;Off; Tracing

3.4 TraceCace Fit 2
25
•
•
•
•
•
•
3.4.3 Switching on/off
► To switch TraceCace Fit 2 on, push the button ( Figure ‘TraceCace Fit 2 with
smartphone (back)’).
► To switch TraceCace Fit 2 off, push the button for more than 5 s. Then, the LED
starts to flash very quickly and TraceCase Fit shuts down.
3.4.4 Tracing
► Insert the smartphone into TraceCace Fit 2 ( Inserting/Removing the
Smartphone).
► Switch on TraceCace Fit 2 by pushing the button.
► Go to the Wi‐Fi settings of your smartphone and connect to the Wi‐Fi network of
TraceCase Fit.
► Start the TraceCase App on your smartphone.
► If the TraceCace Fit 2 status is ‘Ready’, then tap the START TRACING button on
your smartphone and place the antenna on the NFC device.
► Tap STOP (TRACING) on your smartphone to end the monitoring session. The data
is transferred from the TraceCase Fit hardware to the smartphone.
► To save battery power, push the TraceCace Fit 2 button for more than 5 s to switch
it off.
► On the smartphone, enter the session details into the screen that is automatically
displayed afterwards.
► On TraceCase Home, tap SAVED SESSIONS and select the desired session.
► Share the session data.
The antenna of TraceCace Fit 2 is located at the same position as the antenna
of the used smartphone.
For detailed information regarding the trace configuration and editing of ses‐
sion details, refer to
 [TraceCase App].