37
•
•
•
•
•
•
FCC Compliance Statement 6
Federal Communications Commission Radio Frequency Interference Statement
NOTE
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part PCC 47 CFR part 15 subpart C of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio communications. Oper‐
ation of this equipment in a residential area is likely to cause harmful interference in
which case the user will be required to correct the interference at his own expense.
CAUTION
Changes or modifications not expressly approved by the party responsible for compli‐
ance could void the user's authority to operate the equipment. Shielded interface cable
must be used in order to comply with the emission limits.
If the signal generator is used exclusively in a shielded‐room environment to radiate test
signals for evaluation of other devices, it also can be considered exempt from the autho‐
rization requirement of certification. A device used exclusively in a shielded‐room envi‐
ronment to radiate test signals is not classified a transmitter by the commission.
To Next Page
Loading...