CompuSTAR DroneMobile DR-2000

Need help?

Do you have a question about the CompuSTAR DroneMobile DR-2000 and is the answer not in the manual?

Summary

Introduction

Introduction and Notices

Welcome and important guidelines for installing the DroneMobile DR-2000 system.

Installation Overview

Wiring Diagrams

Type 1 - Standalone With RF Kit and Bypass

Wiring connections for Type 1 installation using DroneMobile as a standalone system with an RF Kit.

Type 2 - Data

Wiring connections for Type 2 installation when using DroneMobile with a compatible Firstech Control Module.

Type 3 - Hardwire

Wiring connections for Type 3 installation with a non-data Firstech control module or aftermarket alarm.

Details

Wiring Details

Detailed explanation of the Data Harness and Type 1/3 Hardwire Harness connections for the DR-2000.

Activation and Placement

Dealer Activation

Steps for dealers to activate the DroneMobile SIM and register the unit via the online portal.

Suggested Mounting Locations

Recommendations for optimal placement of the DR-2000 unit within the vehicle for best signal reception.

Programming

Remote Programming Routine

Procedure for coding remotes to the Drone system and understanding the programming sequence.

Valet Mode

Explanation of the DR-2000's valet mode and methods to exit it.

Engine Sensing

Details on tach sensing, tachless mode, and timed crank settings for engine detection during remote start.

Option Tables

Option Group 1

Table outlining features, default settings, and optional settings for Option Group 1.

Option Group 2

Table outlining features, default settings, and optional settings for Option Group 2.

Special Option Groups

Summary tables for Special Option Group 1 and 2, detailing setting values and programmable output connector functions.

Option Descriptions

Option Descriptions (1-01 to 2-08)

Detailed explanations for various system options, including unlock behavior, timers, and inputs.

Option Programming Instructions

Option Programming Using the OP500 (programmer)

Instructions for programming DR-2000 options using the OP500 programmer, including menu navigation and saving settings.

Option Programming Using a Remote

Instructions for programming DR-2000 options using a remote control, including menu selection and setting confirmation.

Troubleshooting

LED Diagnostics

Table showing LED behavior for Cell and GPS signals during connection, transmission, and signal status.

Frequently Asked Questions

Answers to common questions regarding DR-2000 activation, compatibility, car shutdown, and programming modes.