TM
Option Descriptions
1-01 Unlock Before, Lock After Starting. Lock After Remote Start - If enabled, this option will
make the system unlock the doors before remote starting, start the vehicle, then lock the
doors after the vehicle starts. It will then lock the doors again if the remote start run time
expires and the vehicle shuts down. This feature is for vehicles that have factory alarms that
need to be disarmed before remote starting.
1-02 Double Pulse Unlock - If enabled, this option will cause the system to double pulse the
unlock output. This option is used on a majority of Toyota vehicles. The first unlock pulse
disarms the alarm, and the second pulse unlocks the doors.
1-03 Diesel Timer – Use this option for wait to start. You can use setting 2 for a default wait to
start of 10 seconds, otherwise, you can adjust the time with your OP500 Programmer.
1-04 Timer Start or Interval Between Starts - This option dictates the time interval when the
control module will remote start.
Default 1: Will start and run for 4 minutes every 3 hours until the vehicle is remote started
or started by key.
Option 2: Will start and run for 4 minutes every 1.5 hours until the vehicle is remote started
or started by key.
1-05 Remote Start Runtime - This option gives you four different settings for the remote start run
time. The available options are 15, 25, 45, and 3 minutes.
1-06 Engine Sensing – This option selects the method in which the Drone will detect if the
vehicle’s motor is running. At default, it will look for that status through the bypass module.
Option 2 will monitor the vehicle’s battery and option three will crank for 1.5 seconds.
Copyright 2011 Firstech, LLC. | 16
Programming
DR-2000 Install Guide
To Next Page
Loading...
