Comtec ZDR-024CE - Page 62

62
Using parking surveillance mode (optional)
Night vision setting
• Turning this setting ON will allow comparably clearer video footage to be recorded
during parking at night time where there are not many lights. However, in circumstanc
-
HVZKHUHWKHUHDUHQROLJKWVLQWKHVXUURXQGLQJVLWPD\QRWEHSRVVLEOHWR¿OPFOHDUO\
• 5HJDUGOHVVRI>)UDPHUDWHVHWWLQJ@WKHIUDPHUDWHIRUWKHUHFRUGHGYLGHRIRRWDJHLV¿[HGDWISV
• By default, it is set to [OFF].
Impact sensitivity setting
• The sensitivity to detect an impact during parking surveillance mode can
be selected from [High-sensitivity / Medium sensitivity / Low sensitivity].
• By default, it is set to [Medium sensitivity].
Recording time setting
• The operation time for parking surveillance mode can be selected from [30
minutes / 1 hour / 3 hours / 6 hours / 9 hours / 12 hours / Always ON].
• When set as [Always on], it operates until the vehicle battery voltage is reduced
to the voltage set by [Parking surveillance recording stop voltage setting].
• By default, it is set to [30 minutes].
Recording stop voltage setting
• The vehicle battery voltage to stop parking surveillance mode can be se-
lected from [11.9 V / 12.0 V / 12.1 V / 12.2 V].
• By default, it is set to [12.2 V].
*HWRႇFDQFHOVHWWLQJ
• The time set for not recording impacts or vibration as parking surveillance impact recording data,
which is detected at the time of exiting the vehicle, can be selected from [1 minute / 3 minutes].
&RQWLQXRXVUHFRUGLQJZLOOFRQWLQXHGXULQJWKHJHWRႇFDQFHOWLPHH[FOXGLQJZKHQ
impact quick recording is set).
• By default, it is set to [1 minute].
Get-on cancel setting
• The time set for not announcing "Announcement for impact detected when
vehicle is parked" (=> P 59) when an impact or vibration is detected at the
time of exiting the vehicle can be selected from [1 minute / 3 minutes].
3DUNLQJVXUYHLOODQFHLPSDFWUHFRUGLQJGDWDZLOOEHVDYHGRQO\WKHDQQRXQFHPHQWZLOOEHFDQFHOHG
• By default, it is set to [1 minute].