EasyManua.ls Logo

Comtec ZDR-024CE - Regarding Parking Surveillance Mode Operation

Comtec ZDR-024CE
76 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
59
Using parking surveillance mode (optional)
Using parking
surveillance mode
59
Regarding parking surveillance mode operation
Changing to parking surveillance mode
After connecting the HDROP-09 "Parking Surveillance/ Direct Wiring Cord,"
change the [Parking surveillance mode] setting to something other than
OFF. When the vehicle key switch is turned OFF, it will change to parking
surveillance mode.
• When parking surveillance mode is in operation, the
/('ODPSUHSHDWHGO\ÀDVKHVWKUHHWLPHV
* When the [Parking surveillance recording method] setting
is set as [Impact quick recording], the LED lamp is turned
RႇDWDOOWLPHV
• Continuously recorded data in parking surveillance
mode is recorded as "parking surveillance continuous
recording" data, and impact recording data is saved
as "parking surveillance impact recording" data.
Advice
$IWHUWKHYHKLFOHNH\VZLWFKLVWXUQHGRႇDQGZLWKLQWKH>3DUNLQJVXUYHLOODQFHJHWRႇ
cancel] set time, impacts will be considered as vibration caused when exiting the
vehicle and will not be recorded as parking surveillance impact recording data.
Ending parking surveillance mode
• Parking surveillance mode can be ended at the point when the vehicle key
switch is turned ON or ACC, or by pressing and holding the OK button.
• Parking surveillance mode ends after the time set in [Parking surveillance
recording time] has elapsed, and in cases where the voltage goes below
the set value.
Advice
Announcement for impacts detected when the vehicle is parked
When an impact is detected during parking surveillance mode, an announcement will be made at the
time when the vehicle is started up next to notify you of an impact that occurred during parking sur-
veillance mode. After the announcement, recording will not start until the [OK] switch is pressed.
After the vehicle key switch is turned ON or ACC, and within the [Parking surveillance get-on cancel]
set time, impacts will be considered as vibrations caused when exiting the vehicle, and the above
PHQWLRQHGQRWL¿FDWLRQZLOOQRWEHJLYHQ
Parking surveillancemode is active
Flashes in
green 3 times