UGC007/0702 Basic 32 Loader Control
INSTALLATION 3-5
The B32 Input/Output enclosure should be
mounted on a wall, or other secure vertical
surface, at a height providing easy access
and a clear view of the touchscreen panel.
Bolt the control to the
mounting surface. Use the mounting
brackets on the I/O enclosure.
Ground the control enclosure.
Connect a ground wire to the control. Follow procedures
outlined by your regional electrical codes and the wiring
diagrams included with this manual.
MOUNTING
THE CONTROL
1
2
WARNING: Improper installation may
result in equipment damage or personal
injury.
● Always maintain a safe ground. Follow the safe
grounding procedures in the wiring diagram pack-
age. Ground the shielded cable inside the
Input/Output enclosure only.
● Do not operate the equipment at power levels other
than those specified on the the equipment data
plate.
To Next Page
Loading...