Conair Thermolator TW-1 User Manual

UGH025-0504 Thermolator TW Series
APPENDIX D-3
Status, Machine 1
Poll: 0x20 0x42
SPI STATUS WORD
Word BIT position 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
EEprom error SET SET
*
A/D converter error SET SET
*
CJC Error SET SET
*
RAM hardware SET SET
*
ROM checksum SET SET
*
Probe Failure
*
E/M Hi temp safety SET SET SET
*
Prog. Hi temp safety SET SET SET
*
Output monitor failure SET SET
*
Low water pressure SET SET SET
*
High deviation alarm
*
Low deviation alarm
*
Prog. Lo temp safety SET SET SET
*
Pump overload SET SET
*
Low water flow SET SET
*
Low water level SET SET
*
Test Mode
*
Phase error SET SET SET
*
NOTES:
*
The SPI I/O list defines the Processing bit as being cleared if the unit is not processing; otherwise it is SET.
Elsewhere on the chart:
l If a bit is not shown to be SET, it is cleared.
l The System Alarm bit is SET if an alarm is present. It is the logical OR of Process alarm and Machine alarm.
l Processing, System Alarm, Process Alarm and Machine Alarm bits are repeated for Process Status, Machine 1
Status and Machine 2 Status.
TW-1, TW-2 CONTROL SPI STATUS WORDS
Open Alarm, Phase Alarm, Low current Alarm, High current Alarm, Low volts Alarm, High volts Reserved Reserved Alarm, Low pressure safety limit Alarm, High pressure safety limit Alarm, Low temperature safety limit Alarm, High temperature safety limit Alarm, Machine Alarm, Process Alarm, System Processing

Conair Thermolator TW-1 Specifications

General

Brand	Conair
Model	Thermolator TW-1
Category	Control Unit
Language	English