Concept2 INDOOR ROWER - Page 18

18
c. using recall
After you have finished a workout, you can use RECALL to view your performance during each split or
interval of your workout.
The first press of the RECALL button displays the end of workout information for your workout. Each
successive press of the RECALL button shows the next earlier split or interval until either the last split
has been displayed or there is no more memory available (maximum storage is 20 splits or intervals).
The word “SPLIT” will appear on the screen to indicate that you are viewing split information as opposed
to end of workout information. Default splits are: 2 minutes for timed workouts and 500 meters for dis-
tance workouts. See next section to set custom splits.
NOTE: Your workout results will remain in the PM2 memory until another
workout is started, even if the PM2 is turned off.
RECALL DISPLAY CHART
Type of Workout Splits Taken Recall Display
automatic every 2 minutes
count up mode (or custom split interval if set)
tips:
•The button works the same as RECALL. It shows the next earlier split or
interval.
•The button shows the next later split or interval.
•TheDISPLAYbuttoncanbeusedduringsplitrecalltoviewsplitsinvarious
units.
•PressingRESTduringsplitrecallshowssplitsincumulativemode.Thisis
indicated to the user by “CU” in the center display field. Press REST again
to exit CU mode.
•HEART RATE box shows your HR at the end of that interval or split
•SPMboxshowsyouraveragestrokesperminutefortheintervalorsplit.
preset timed every 2 minutes
workout (or custom split interval if set)
preset distance every 500 meters
workout (or custom split interval if set)
preset timed at end of each time interval
intervals
preset distance at end of each distance interval
intervals