Battery Alarm
If the input battery voltage is less then the alarm’s setting, the Battery Alarm will sound and
a message will appear on the screen. The available setting is 10.0~18.0 volts. At the lower
right corner of Battery Alarm interface, the currently working voltage is displayed.
To set the Battery Alarm:
a) Press MENU to enter into menu setting,
b) Repeatedly press MENU to switch to Alarm menu.
c) Use the Up / Down Arrow to select Battery Alarm option.
d) Press ENT to enter into setting.
e) Use the Up / Down Arrow to increase / decrease the value.
f) Press ENT to confirm and exit the setting.
Note: once triggered, an alarm message will appear on the screen. You can press any key
two times to clear the alarm message.
However the alarm will repeatedly appear unless the voltage of the battery is higher than
the Battery Alarm setting.
You can manually choose exiting the Battery Alarm Mode by entering into Battery alarm
menu setting, and just changing the setting to a safe value will be ok.
SYSTEM
Beeper
Beeper is used to determine whether the fishfinder will sound a
tone when a key is pressed.
To set the Beeper:
a) Press MENU to enter into menu setting,
b) Repeatedly press MENU to switch to System menu.
To Next Page
Loading...