6
Installation
Do not begin the installation unless you have read the manual instruction carefully, which
contains information critical to the correct installation of your Fishfinder. And for any
problems you meet during the installation, please contact your local dealer for help.
Tranducer transom location (suction cup version)
1. Select the mounting location
When you select a mounting location for the transducer, the flowing should be considered
in advance.
The sonar transmission / reception can be affected severely in turbulent water, so please
do not mount transducer behind strakes, rows of rivet, water intake, discharge port, the
immediate area of the propeller(s). These areas can create turbulence when the boat
moves in a high speed.
Do not mount the transducer in locations where it may be vibrate severely when the boat’s
engine launches or stop.
After the installation is finished, make sure the transducer is pointed down straightly to the
water surface.
2. Portable Transducer Assembly
Assemble the transducer and the suction cup as shown in the following illustrations.
Make sure there is one washer on each side of the transducer, inside the bracket. Slide the other
washer over the end of the bolt and screw on the nut.
Screw the suction cup onto the bracket using the supplied screw and flat washer. Tie the
nylon cord through the hole in the top of the bracket. When using the transducer, tie the
other end of the nylon cord to the boat. This will help prevent losing the transducer if it
comes off.
To Next Page
Loading...