Conel CLEAR SOFT - Resetting to Factory Settings; Display Message Overview

72
6.11
RESETTING TO FACTORY SETTINGS
All user-defined settings can be reset to the factory settings as follows:
Press
. The display will show the following:
Press
. The display will show the following:
Press <OK> once and then
 five times. The display will show the following:
Press <OK>. The display will show the following:
Press
 or  to change between <yes> and <no>.
When <yes> is selected, the following default values are restored by pressing <OK>:
/ Raw water hardness 20 °dH
/ Backlight 80 %
/ Contrast 80 %
6.12
DISPLAY MESSAGE OVERVIEW
Hauptmenü
· Regeneration
Hauptmenü
· Einstellungen
Einstellungen
· Werkseinstellg.
Werkseinstellg.
<nein>
Display Description Further information
Wartung/
Service
Message shown after an annual
maintenance period.
see chapter 9.4 “MESSAGE “MAINTE-
NANCE/SERVICE””
Achtung!
Salzmangel
Shown after value falls below mini-
mum chlorinating flow.
see chapter 6.6.1 “MESSAGE IN CASE OF
INSUFFICIENT SALT”