Contherm MITRE 4150 - Replacing the Inner Door Seal

MANUALP/4000_SERVICE_0712 July2012
48
Servicing Procedure:
Replacing the Inner Door Seal
The instruction below demonstrates how to remove the inner door seal from
the cabinet. Suitably qualified service personnel should only carry out this
procedure.
Schedule of servicing:
As and when needed.
Safety requirement:
1. Ensure that the cabinet is unplugged from the power source.
2. Ensure that there are no specimens inside the cabinet.
Servicing Procedure:
1. Ensure the safety requirements are in place.
2. For the purpose of describing the
procedure, a 2-glass door sized
cabinet will be used. However,
the procedure is the same for a
single glass door sized cabinet.
3. Open the glass door and locate
the termination of the inner door
seal.
Main Door
Glass Door
(TOP)
Glass Door
(BOTTOM)
Glass Door
Inner Door Seal
(Terminations)