Contrec 212 - Page 48

212-M-V2.1
46 Input & Output Connections
Parameter Value Description
25. BUS xx ADDR Bus address for the communications
link.
NO
Display will revert to Energy Total if no
key has been pressed for 10 seconds.
Display will stay on the last
displayed parameter.
27. Fr RES YES
NO
Enable RESET key on front panel.
Disable RESET key.
28. PK/OPK OFF
ON
Selects whether Energy will be totalised
in separate Peak and Off-Peak registers.
If set to OFF, Set-up continues at step 30.
29. PK ON xx
hour
Sets the hour at which energy
totalisation will commence in the PEAK
register.
(Only available if mode is set to Heat,
Cool or Heating/Cooling.)
30. PK OFF xx
hour
Sets the hour at which energy
totalisation will commence in the OFF
PEAK register.
(Only available if mode is set to Heat,
Cool or Heating/Cooling.)
31. LOG OFF
MONTH
WEEK
DAY
HOUR
Selects the interval at which Logging
will take place.
Logging is only available if the mode
(step 2) is set to Heating, Cooling or
Heating/Cooling and the Peak/Off-
Peak (step 27) is set to OFF. If
logging is not available, this step
will not be displayed.