Resetting the Logger VFC400-WiFi User Guide 49
Resetting the Logger
You can reset a logger back to its original READY state. Once reset, recording can be started again.
When performing this procedure all recordings and statistics stored in the logger are deleted and
cannot be recovered. Please ensure your data have been saved!
All settings in the logger, including Wireless and Network settings, are retained.
For this process to work, the logger must be STOPPED.
l Press and hold the
START/CLEAR/STOP button. The
READY symbol will flash.
l
When the READY symbol remains permanently on,
release the button within 2 seconds. The STOPPED
symbol will turn off and the logger is now ready to be
started again.
The ability to reset a logger is enabled or disabled in the Advanced Settings tab when configuring the VFC400-
WiFi via Control Solutions VTMC .
Hibernating a VFC400-WiFi
When hibernated, the logger’s power consumption is near zero. Hibernating a logger is useful for conserving
battery life when the logger is not used for extended periods.
If you hibernate the logger for longer than a week, please remove the AAA batteries from the logger to avoid
them leaking.
VFC400-WiFi loggers are placed into Hibernation using Control Solutions VTMC by clicking Hibernate from the
LogTag menu.
Initially, the display shows SLP on the display until you remove
the logger from the USB port.
To Next Page
Loading...