Control Techniques Unidrive 1401 User Manual

Safety
Information
Product
Information
Mechanical
Installation
Electrical
Installation
Getting
Started
Menu 0
Running
the motor
Optimisation Macros
Advanced
Parameters
Technical
Data
Diagnostics
UL Listing
Information
Unidrive User Guide 143
Issue Number: 9 www.controltechniques.com
10.6 Menu 6: Sequencing logic
Figure 10-11 Menu 6 logic diagram
* For more information, refer to section 10.22.4 Stop Modes on
page 184.
** For more information, refer to section 10.22.5 Mains loss modes on
page 185.
*** For more information, refer to section 10.22.6 Sequencing Modes on
page 186.
**** For more information, refer to section 10.22.7 Catch a spinning
motor on page 187.
6.30
Sequencing
bit 0
6.31
Sequencing
bit 1
6.32
Sequencing
bit 2
6.33
Sequencing
bit 3
6.34
RUN PERMIT /
STOP
6.01
Stop mode
selector*
6.02
Auto-start
mode selector
6.04
Sequencing
mode selector***
6.05
Minimum
jog time
6.29
Hardware
enable
6.08
Hold zero
speed enable*
6.03
ACsupply loss
mode selector**
Sequencer
6.35 Limit switch 1
6.36 Limit switch 2
Logic
1
6.11
Keypad RUN
key enable
6.12
Keypad STOP
key enable
6.13
Keypad FWD/REV
key enable
1.11
Reference
enabled indicator
1.12
Reverse selected
indicator
1.13
Jog selected
indicator
RUN
STOP/
RESET
FWD/REV
RESET
1.49
Reference
selected
indicator
Logic 1
6.09
Synchronize
to a spinning
motor****
6.15
Drive enable
Open loop only
6.06
Injection
braking level
6.07
Injection
braking time*
6.10
Spinning motor
ramp rate****
6.37
Synchronization
start-voltage****
6.38
Synchronization
voltage ramp****
6.17
Power consumption
meter reset
6.18
Time interval between
filter changes
6.19
Filter change
required/done
6.20
Time interval
between lubrication
6.21
Lubrication
required / done
6.16 Electricity cost
Clock control
6.25
6.24
Power meter
6.28 Time before
lubrication due
6.26 Running cost
6.27 Time before filter
change due
Inverter enable
Menu 13
Position control
Relative jog
Relative jog reverse
select
select
Closed-loop only
Menu 2
Menu3
Ramp /
Hard speed
reference
enable
disable
disable
6.22
Run-time log
6.23
Run-time log
5.03
Tota l m o to r
power
0.XX
0.XX
Key
Read-write (RW)
parameter
Read-only (RO)
parameter
Input
terminals
Output
terminals
The parameters are all shown at their default settings

Control Techniques Unidrive 1401 Specifications

General

Brand	Control Techniques
Model	Unidrive 1401
Category	Controller
Language	English