Coolaroo Custom - Shade Removal; Shade Maintenance and Cleaning

23
Standard Shade Removal
IMPORTANT: Using too much force when removing the roll
can cause the Idle Bracket Assembly to break. If it breaks,
please contact customer service for a replacement part.
•
Roll the shade up fully.
•
With a athead screwdriver, press upward in the opening
on the Idle Bracket Assembly while pulling forward on the
idle side of the shade.
•
Once the shade is released from the bracket, slide the
Control Side of the roller shade out.
WARNING: Roll up your shade when not in use or
before strong winds to prevent damage.
Cassette Shade Removal
•
Roll the shade up fully.
•
While holding the Cassette, press on the
Release Tabs on all three mounting Cassette
Brackets one at a time releasing each one. Be
sure to secure the shade while doing so.
•
Roll the Cassette o the brackets and remove.
WARNING: Roll up your shade when not in
use or before strong winds to prevent damage.
SHADE REMOVAL
Insert athead
screwdriver into this
opening and press upward
to release the shade
Idle
End
Shade
Press Release Tab on all
mounting brackets
Roll cassette
o bracket
Slide shade
o bracket
SHADE MAINTENANCE AND CLEANING
Lightly clean by hosing down with water. For stubborn stains, scrub with soap or any non-abrasive cleaner. Leave
your shade rolled open to air dry. In humid climates or moist areas, roll shade down frequently to air out.
WARNING: Use of solvents or abrasive cleaners may damage the fabric and will void your warranty. Do
not use bleach or chlorine.