COOLIUS A10 - Company Data

20
COOLIUS A10
4.5.3 Company data
Turn COOLIUS SELECT to select.
Press ENTER to conrm.
5 lines are available:
1_________ Company name (Workshop)
2_________ Address (road, etc..)
3_________ City
4_________ Phone
5_________ FAX
The above setting is an example only.
NOTE: The ve lines are reported on the service report.
Procedure:
• Turn COOLIUS SELECT to select the character.
Press ENTER to conrm.
The character is reported on the rst line (left).
• If required, press X key to delete.
• It is possible to move in the line by LEFT / RIGHT
• Turn COOLIUS SELECT to select the next character.
Press ENTER to conrm.
The character is reported on the rst line.
• Press START key to conrm the setting.
The display shows the following line.
• Press STOP when the 5 lines are set.
1_________
C
567890 AB DEFGHIJKLM
4.6 Maintenance messages
At the start-up is possible to see the following messages:
Notice: “
MAINTENANCE WILL EXPIRE SOON!” or “MAINTENANCE EXPIRED”
The message
MAINTENANCE WILL EXPIRE SOON! can be skipped.
Press STOP to continue with the start-up of the machine.
1. At the message
MAINTENANCE EXPIRED!
UNLOCK CODE REQUIRED
press the STOP key, then
the display shows..
2. Write down the code shown at the end of the sec-
ond line and use it to get the UNLOCK CODE on the
website www.coolius-ac.com or by hotline phone call
+497940981888188.
3. Press STOP to continue with the start-up of the ma-
chine.
NOTE:
See chapter 6.3 Counter reset (UNLOCK CODE required) p. 35 to reset the maintenance
counter.
Maintenance expired!
UNLOCK CODE required
Get UNLOCK CODE
register: BB111111
www.coolius-ac.com