COOLIUS A10 - Full Service

26
COOLIUS A10
5.3 Full service
1. Press ENTER to go to selection menu (if in Stand-by
mode).
2. Turn COOLIUS SELECT to select “
FULL SERVICE”
3. Press ENTER to conrm.
4. Turn COOLIUS SELECT to set the amount of refriger-
ant to be charged into the A/C system.
• Minimum: 50 g.
5. Press ENTER to conrm.
6. Turn COOLIUS SELECT to set (usually HP)
“
HP PORT” / “LP PORT” / “HP/LP PORTS”
7. Press ENTER to conrm.
Equipment with printer:
See chapter 4.2 Using the printer p. 14
8. Press START key to conrm.
The equipment performs all the processes.
• Recovery
• residual refrigerant check
• used oil drain process
• Vacuum, Leak test
• New oil charge
• UV Dye charge
• Refrigerant charge
9. At the end of the processes,
start the engine and A/C system, then check the pres-
sures.
10. At the end of the verication, press STOP key to end
11. Perform the instruction.
12. Press START key to conrm.
Full service

Set charge amount:
Quantity g. 500
Charge A/C system by
HP PORT
Confirm by “START“
Verify the A/C
system pressures.
Disconnect the HP/LP
service hoses from
the A/C system.
Refrigerant recovery
from the
service hoses