Public Access Level 1 (Faults)
Touch any of the category buttons for further details of affected devices.
X Lamp Faults
X Comms Faults
X Other faults
Level 1
0 Disabled0 Faults 0 In test
Mute Buzzer
Back
Level 1
Mute
Buzzer
DD-MMM-YY HH-MM-SS Lamp Fault
Loop XX Address XX SCAEL Group XX VV IImA
Back
Level 1
Mute
Buzzer
Time
Event
Text
Panel
Loop
Address
Type
Group
Voltage
Current
(Date and time) DD MMM YYYY HH MM SS
Fault type
Fitting location text
Panel name / Number
Loop number
Device address
Interface type
Test group
Last voltage reading
Last current reading
Touch a device
on the list for
full technical
details.
Touch here to send
the device into a
manual test to
confirm current
status, touch again
to end test.
Not in
test
Level 1
0 Disabled0 Faults X In test
Mute Buzzer
X loops
X Groups
X Addresses
Public Access Level 1 (Disabled)
Disabling a device causes all communication between the panel and the device to be
suspended whilst ever the device is disabled.
This results in the fitting no longer being tested by the panel in accordance with any pre-
programmed test sequences, similarly any fault or error messages sent from the disabled
devices to the panel will be ignored.
Device disable is convenient method for avoiding unwanted error messages from devices with
known long term faults, (such as devices removed from service.)
It is however important that devices are not unintentionally left disabled for longer than
necessary, therefore indication is provided at the display of any disabled devices.
An LED indicator on the main display also illuminates whenever any devices are disabled.
Touch here for a list of
individual addresses.
isolated
Touch here for a list of entire
test groups.
isolated
Touch here for a list of entire
panel loops.
isolated
Level 1
X Disabled0 Faults 0 In test
Mute Buzzer
To Next Page
Loading...
