Coredy FL022 - Page 25

23
You can use the App to set up restricted zone or virtual
wall. After the setting is completed, Coredy Robot FL022
will not enter the restricted zone or cross the virtual wall for
cleaning.
Set a no-go zone or virtual wall
You can use the App to set the scheduled cleaning time.
When the specified time arrives, Coredy Robot FL022 will
automatically start cleaning, and return to the charging
dock after it completes a cleaning.
Scheduled cleaning
You can use the App to configure a zone for cleaning.
Coredy Robot FL022 will start cleaning based on the zone
that you plan on the App.
Configured zone cleaning
You can use the App to select the Eco, Standard, and
Strong suction modes. The Standard mode is selected by
default.
Cleaning suction mode
With this function enabled, when the robot runs out of
power during cleaning and the area has not been cleaned
completely, the robot will come out and clean the area that
was just not cleaned after recharging to 80%.
Continue cleaning at breakpoint
During the Do-Not-Disturb (DND) period, Coredy Robot
FL022 will not automatically continue cleaning or playing
the voice prompt. You can use the App to disable the DND
mode or change the DND time range.
DND MODE
With this function enabled, the robot will clean the floor with
the “Y” shape. If the robot is already cleaning, it will not
change into the “Y” shape cleaning immediately. The robot
will not start the “Y” shape until the next cleaning.
Y-Shaped Mopping
Note:
Before using this function, you need to enable the Map Save
Mode for the Robot which you can set at Room Manage on
the App.
This function is only used to divide cleaning zones, but
cannot be used to block dangerous zones.
If Coredy Robot FL022 is moved or there are significant
changes in the home environment, the map may become
invalid and the settings of the virtual wall or restricted zone
may be lost.
Note:
After cleaning starts, the FL022 Robot may move to a place
beyond the configured zone. Make sure that you have
cleared the obstacles on the ground around the configured
zone, which cannot be used for safety isolation.