Cold Nitro Brew BIB Dispenser Operator’s Manual
Publication Number: 621058723OPR ‐ 18 ‐ © 2017, Cornelius Inc.
CHANGING A BIB CONTAINER
When changing a product BIB container, orient the BIB with the connector hose upward to
prevent spillage during product hose disconnection. Be sure to clean up any spillage.
3
Fill the ice bank with potable water.
A. Use a funnel and pour water into refill opening. Capacity
is approximately 3.6 gallons (13.6 liters). The reservoir is
full when water begins trickling through the overflow
tubing at the lower-front, center of the ice bank.
NOTE: The ice bank may also be filled with chilled water
to reduce the time for cool down to 33°F (0°C). (Typical
cooling time using room‐temperature water is 6 hours.)
NOTE: The ice bank typically requires a water refill every
month. Observe the water level shown in the drain tube
(with red cap). Remove cap for accurate reading.
B. Replace the filter, cover, and grille in reverse order
from step 1 above
Table 4
Pour Water
into Opening
Overflow
Connection
Table 5.
Step Action
1 Open the cabinet door.
2
A. Disconnect the product line connector from the empty
BIB by unscrewing the BLACK threaded ring counter‐
clockwise.
B. Remove the empty BIB container and properly discard
it.
To Next Page
Loading...
