KIT Base Unit ED175 Installation Instructions
Publication Number: 629097525INS - 8 - © 2016, Cornelius Inc.
Figure 10.
4. Connect the 30" jumpers to the control board & route the jumpers out of electrical box through the bushing
installed in the above step (See Figure 6).
NOTE: Agitation will occur.
5. Connect one end of the jumper to the keypad to test the keypad & valve functioning. Temporarily connect
power to the unit. See Figure 11.
Figure 11.
Test flavor keypad for valve solenoid operation, check soda valves for normal operation as well.
NOTE: Disconnect power once the keypad operation has been successfully tested. Install guide clip to
th
e bottom side of electrical box to secure jumper slack. Secure any remaining harnesses
under electrical box with cable ties.
Figure 12. ED175 Solenoids
(Right Side Shown)
Figure 13.
To Next Page
Loading...
