© 2010, IMI Cornelius Inc.
- 34 -
6. Loosen the V - band clamp and
remove pump.
Pump V - Band
7. Install new pump by reversing this
procedure.
NOTE
-- Be sure there is anti-seize
compound on the pump Pump Tang
drive tang.
PUMP MOTOR REPLACEMENT
1. Disconnect power to the unit.
2. Remove the following:
• front merchandiser by removing screws on the top and lifting up
• key switch wires
• hood by removing screws on
1
the top and lifting up and forward.
3. Unplug motor harness.
4. Loosen the V - band clamp and
remove pump.
Pump V - Band
Water and CO2 to the system must be turned off and the system depressurized prior to performing
this service.
Failure to comply could result in serious injury,death or damage to the equipment.
WARNING
Disconnect power to the unit before servicing following all lock out\tag out procedures established
by the user.Verify all power is off to the unit before performing any work.
Failure to comply could result in serious injury,death or damage to the equipment.
WARNING
To Next Page
Loading...
