CUSTOMER MANUAL M400 DRIVE SYSTEM
84
5.5 Switching the electrical system
on and off
Push the power button to turn on the electrical system. To
turn it off, push and hold down the same button until the
system turns off.
Conditions:
In order to activate and use your Pedelec, the following
prerequisites must be fulfilled:
• A sufficiently charged battery must be used.
• The battery must be inserted correctly into the battery
holder.
• The motor, control unit, battery, etc. must all be
connected correctly.
Always squeeze the brakes of your Pedelec before placing a
foot on the pedal! The motor starts propelling as soon as
you step on a pedal. This boost is unusual and can lead to
falls or cause dangerous traffic accidents and injury to occur.
1
2
The motor support is dependent on how fast or slowly you
pedal. The faster you pedal, the higher the motor support
level becomes. The motor stops supporting your ride once
you stop pedaling. Motor support is reactivated as soon as
you begin pedaling again.
If the battery of your Pedelec is equipped with an on/off
switch, you can also press the switch on the battery.
On/Off Operating Switch
To Next Page
Loading...
