CUSTOMER MANUAL M400 DRIVE SYSTEM
96
10 PARTS ALLOWED TO BE CHANGED ON
S-PEDELEC/PEDELEC
10.1 These S-Pedelec parts may be
changed
During the bike’s approval procedure, it is determined
which parts may be used for this bike. In other words, the
Pedelec is only permitted if your vehicle uses these parts
or replacement parts which have been approved for use
with your model.
If parts are subsequently changed, please replace these
with original parts or replacements which are approved for
used on your Pedelec, otherwise you must seek individual
permission from the TÜV or your local regulatory authority.
10.2 These Pedelec parts are
allowed to be changed
Guide for parts which may be changed on CE-approved
Pedelecs with assisted pedalling up to 25 km/h.
Category 1
Components allowed to be changed only with permission
from the bike’s manufacturer/system provider:
• Motor
• Sensors
• Electrical steering
• Electrical cables
• Control panel on the handlebars
• Display
• Battery pack
• Charger
Category 2
Components allowed to be changed only with permission
from the bike’s manufacturer:
• Frame
• Suspension strut
• Bike fork and suspension fork
• Wheel for the hub motor
• Brake system
• Brake linings (rim brakes)
• Luggage racks (luggage racks determine how much
weight the wheel can carry). Both positive and
negative changes made to the bike can potentially
impact the bike‘s drivability as compared to that
implied by the manufacturer.)
Category 3
Components allowed to be changed according to the bike
or bike part’s manufacturer:
• Foot pedal (only if the distance between the pedal
attachment points and crank arms, i.e. the q factor, are
adhered to.)
Category 4
Components not requiring any special kind of approval to
be changed:
• Chain rings/pulley/sprocket (only if the number of
teeth and the diameter are the same as described in
the bike’s original description.)
To Next Page
Loading...
