18
ELECTRICAL CONNECTION
WARNING
ELECTRICAL SHOCK HAZARD
WARNING
EXCESSIVE WEIGHT HAZARD
IMPORTANT:
• Turn off the circuit breaker or remove house fuse to the oven branch
circuit before servicing.
• This appliance must be properly grounded.
• Do not use an adapter or an extension cord.
• Failure to do so can result in death, fire, or electrical shock.
• Use two or more people to move and install oven. Failure to do so can
result in back or other injury.
• Installation work and repairs should only be performed by a qualified
technician in accordance with all applicable codes and standards.
Repairs and service by unqualified persons could be dangerous and the
manufacturer will not be held responsible.
• Before connecting the appliance to the power supply, make sure that the
voltage and frequency listed on the rating label correspond with the
household electrical supply. This data must correspond to prevent
appliance damage. Consult an electrician if in doubt.
• The oven must connect to a single-phase (split-phase), 3-wire or 4-wire,
120/208 VAC or 120/240 VAC, 60 hertz electrical system. This appliance
must be supplied with the proper voltage and frequency, and connected
to an individual, properly grounded branch circuit protected by a circuit
breaker or time-delay fuse. It is the personal responsibility of the oven
owner to provide the correct electrical service for this oven.
To Next Page
Loading...
Need help?
General
