INSTALLATION INSTRUCTIONS
IMPORTANT: This appliance shall be installed only by authorized persons and
in accordance with the manufacturer's installation instructions, municipal
building codes, and electrical wiring regulations.
15
• A single-phase (split-phase), 3-wire or 4-wire, 120/208 VAC or 120/240
VAC, 60 hertz electrical system must be used. It is the personal
responsibility of the oven owner to provide the correct electrical service
for this oven.
• Effective January 1, 1996, the National Electrical Code requires that new
construction (not existing) utilize a 4-conductor connection to an electric
oven. When installing an electric oven in new construction, mobile home,
recreational vehicle, or an area where local codes prohibit grounding
through the neutral conductor, refer to the section on 4-wire connections
• An
appropriately sized, UL conduit connector must be used to correctly
attach the conduit to the junction box.
• DO
NOT shorten the flexible conduit. A UL listed or CSA approved conduit
connector must be securely attached to the junction box and the flexible
conduit must be securely attached to the connector clamp. If the flexible
conduit will not fit within the clamp, do not install the oven until a clamp
of the proper size is obtained.
CAUTION
LACERATION, FOREIGN OBJECT, CRUSH HAZARD
• When installing, moving, or servicing any appliance, wear proper
protective equipment, including cut resistant gloves, steel-toed shoes,
and safety glasses.
To Next Page
Loading...
