6
IMPORTANT SAFETY INSTRUCTIONS
WARNING: To reduce the risk of fire, electrical shock, injury to persons, or
damage when using the appliance, follow basic precautions, including the
following:
• Proper Installation – The
appliance, when installed, must
be electrically grounded in
accordance with local codes, or
in the absence of local codes,
with the National Electrical
Code, ANSI/NFPA 70 or the
Canadian Electrical Code, CSA
C22.1-02. In Canada, the
appliance must be electrically
grounded in accordance with
Canadian Electrical Code. Be
sure your appliance is properly
installed and grounded by a
qualified technician.
• Read all of the installation
manual before installing the
oven.
• Disconnect power before
servicing.
• Remove all packing material
before connecting the electrical
supply.
• WARNING: Never cover any
slots, holes or passages in the
oven bottom or cover an entire
rack with materials such as
aluminum foil. Doing so blocks
airflow through the oven and
may cause carbon monoxide
poisoning. Aluminum foil linings
may also trap heat, causing a
fire hazard.
• Injuries may result from misuse
of appliance doors such as
stepping, leaning, or sitting on
the doors.
• Maintenance – Keep appliance
area clear and free from
combustible materials, gasoline,
and other flammable vapors
and liquids.
• User Servicing – Do not repair or
replace any part of the
appliance unless specifically
recommended in the manual. All
other servicing should be
referred to a qualified
technician.
• Do not use replacement parts
that have not been
recommended by the
manufacturer (e.g. parts made
at home using a 3D printer).
• Proper Disposal of Your
Appliance – Dispose of or recycle
your appliance in accordance
with Federal and Local
Regulations. Contact your local
authorities for the
environmentally safe disposal or
recycling of your appliance.
READ AND SAVE THESE INSTRUCTIONS
To Next Page
Loading...
Need help?
General
