18 INSTALLATION MANUAL
INSTALLATION
Required tools for complete
installation
Scissors or a retractable utility knife
Robertson screwdriver
Rubber mallet
Hammer
Phillips screwdriver
50 ft. (15 m) Ratchet straps
7/16’’ (11 mm) socket wrench and spanner
1/2’’ (13 mm) socket wrench and spanner
5/32″ (4 mm) Allen key (Supplied)
25′ (7.6 m) measuring tape
SAE or metric Socket kit
48 in. (122 cm) level
CAUTION
The Covana cover should be installed by a
certified Covana installer. Having the Covana
cover installed by someone who is not certified
will void the warranty. Ask your local Covana
dealer for information on certified installers.
Uncrating
1) Before uncrating the unit, ensure there is no
visible damage to the crate. In the event of
suspicious damage, take pictures first. If any
damage is discovered, please call Covana
customer service immediately.
2) Always stand the crate in the vertical position.
Ensure that the uncrating can be done safely
given the wind conditions. (Figure 27)
3) Remove the cardboard on the front side. (Figure
27)
4) Hammer off the wood furring strip by hitting on
the inside of the side panels. (Figure 28)
CAUTION
Be careful not to damage the cover components
and other parts in the crate. (Figure 28)
Flatten any protruding nails.
To Next Page
Loading...
