What to do if COVANA EVOLUTION COVER cover seal turned black?
If the COVANA Spa Accessories cover seal has turned black, it likely has accumulated mold. Clean the affected areas with bleach and a soft brush, then rinse well with water.
What to do if COVANA Spa Accessories cover raises but does not lower?
To troubleshoot a COVANA Spa Accessories cover that raises but does not lower: remove power before performing any electrical work and ask a certified electrician only. Open the operator and check for faulty up and down limit switches. Also, check for any corrosion on the terminals and clean if necessary. Open the key switch and check for a faulty switch. Finally, check if any electrical cables are damaged or pinched.
What to do if COVANA EVOLUTION COVER cover lowers but does not raise?
To troubleshoot a COVANA Spa Accessories cover that lowers but does not raise: remove power before performing any electrical work and ask a certified electrician only. Open the operator and check for faulty up and down limit switches. Also, check for any corrosion on the terminals and clean if necessary. Open the key switch and check for a faulty switch. Finally, check if any electrical cables are damaged or pinched.
What to do if COVANA EVOLUTION COVER Spa Accessories posts are not equally positioned?
If the posts of your COVANA Spa Accessories are not equally positioned, lower the cover completely and fasten the post back in at the correct height if the post screws attached to the outer shell are loose. Also, verify whether a drive shaft has fallen off and, if so, reinstall it. If needed, lower the cover and replace the chain or replace any missing or broken spring pin by lifting the outer sleeve, using an awl and a hammer. Ensure to remove all debris from the top of the cover.
What to do if COVANA EVOLUTION COVER Spa Accessories middle sleeve has gripped?
If the middle sleeve of your COVANA Spa Accessories has gripped and might have dropped abruptly, verify the position of the all-weather seal. Check whether the stopper kit is broken or missing. Reinstall the sleeves and check the level on 2 faces of the sleeve.
General| Dimensions | Varies by spa size; designed to fit most standard spas up to 8ft x 8ft |
|---|---|
| Color Options | Multiple color options available |
| Locking | Yes |
| Size Options | Designed to fit various spa sizes up to 8ft x 8ft |
| UV Protection | Yes |
| Structure Material | Aluminum |
| Core Material | High-density foam |
To Next Page