page-42 EVOLUTION COVER
NON-PERMANENT MOUNTING PLATE
If you don’t have non-permanent mounting plates,
skip this section.
NOTE
This setup is only available for spa base sizes
larger than 82" wide for standard Covana units and
87" wide for long side Covana units.
1.
After the unit has been installed, but before
installing the seal, proceed with the non-
permanent mounting plate installation. Using
the key switch, lift up the cover to make room
to slightly lift up the spa.
NOTE
Three installers are required. Two installers should
lift the spa at one end approximately 4" off the
ground while the third installer slips the non-
permanent mounting plates under the spa and
hooks them over the U-frame see Figure 70 and
Figure 71.
FIGURE 70: LOCATION OF THE PLATES
FIGURE 71: PLATE AND U-FRAME
2.
Repeat step on the other side as shown on
Figure 71
NOTE
The plates must be installed over the U-frame (two
on each side).
3.
The proper disposition of the plates is
determined by the size of the spa. Position
the plates close to the corners of the spa.
4.
Once the plates are under both sides of the
spa and once they have been properly
240799 OWNER'S MANUAL REVISION 4
To Next Page
Loading...