COVANA EVOLUTION COVER - Installation Checklist (Installer Copy)

EVOLUTION COVER page -53
INSTALLATION CHECKLIST (INSTALLER COPY)
To ensure proper installation you must carefully read this checklist and confirm that you have completed all steps
of the installation. The customer must receive a completed copy of this checklist.
(Please check each circle when the point is completed)
O
The base preparation steps are done correctly (Location and Foundation preparation sections).
O
The installation steps are done correctly (Unpacking, Cover assembly, Lifting mechanism and Electrical
connections sections).
O
The seal is properly installed and there is no steam leaking out around the cover (Seal application section).
O
The wipers are properly installed to make sure the cover is watertight (Wiper installation section).
O
The key switch is permanently installed at least 5 ft (1.5 m) away from the spa and 5 ft (1.5 m) from the
ground.
O
The electrical portion of the installation was done by a certified electrician (Electrical connections, Limit
switch adjustment sections).
O
All parts supplied and included into the crate are installed.
O
The start-up procedure is completed (The key sequence responds correctly and Testing the cover section
is completed).
O
The all-weather seal works properly (The cover raises and lowers properly).
O
The middle sleeves slide freely (Manually slide the middle sleeve up and down when the cover is half
open).
Serial number: ____________________________________________
Installer name: ___________________________ Signature: ____________________________________
Customer name: __________________________ Signature: __________________________________
Customer address: ____________________________________________
Date (YYYY/MM/DD): ____________________________________________
Dealer name : ____________________________________________
240799 OWNER'S MANUAL REVISION 4