COVANA EVOLUTION COVER - Seal Installation

EVOLUTION COVER page-43
positioned over the U- frames, you may
continue with the seal installation.
SEAL INSTALLATION
WARNING
The recommended tool to install the seal properly
is a J-Roller with rubber roller (Covana part no.
239693), see Figure 72.
The roller is not included in the tools. It must be
free of scratches, clean and non-abrasive.
Covana is not responsible for any misuse of the
tool and any damage done to the spa or the cover
while using the roller.
CAUTION
It is recommended to install the seal when the
ambient temperature is above 50 °F (10 °C)
Before installing the seal, it is strongly
recommended to reduce the water vapor steam
generated by the spa. To do this; stop the agitation
of the water by turning off the recirculation pump,
and then set the temperature of the spa water to be
between 2 and 5 degrees under the ambient
temperature. Wait until the water has the ambient
temperature or use a plastic canvas to stop the
vapor steam.
FIGURE 72: J-ROLLER WITH RUBBER ROLLER
1.
Once the cover has been fully mounted, raise
the cover and remove the foam spacers and
tape.
FIGURE 73: REMOVE FOAM SPACERS AND TAPE
2.
Lower the cover and walk around the entire
perimeter of the spa. Check where the inside
surface of the cover makes contact with the
spa. This determines the best location to
install the seal.
3.
Dry the spa top edges and the underside of
the cover with a clean cloth.
WARNING
The spa top edges must be 100% dry and clean.
Use isopropyl alcohol (IPA) if necessary.
240799 OWNER'S MANUAL REVISION 4