EVOLUTION COVER page-63
3.
Quickly rinse very thoroughly to remove all
traces of soap; otherwise, a film will build up
giving the panel a dull, dirty appearance.
WARNING
Never use a pressure washer or high pressure to
clean the cover. The high pressure could puncture
the fiberglass roof.
Never use harsh detergents that may cause a
chemical reaction and permanently damage the
surface.
Never use water hotter than 130 °F (54 °C), this
may cause melting of the fiberglass panels.
Do not use abrasive cleaners.
Do not use a cleaner or stain remover that contains
chlorinated hydrocarbons or aromatic
hydrocarbons.
POST GREASING
This unit will require the following greasing
maintenance to ensure the best performance.
The internal jacks require yearly greasing. Early in
the fall season is the best time. The “Mobil Epic EP
MOLY Grease” is recommended for cold and hot
climates. Ideally, a sprayable grease or an
equivalent low temperature synthetic grease.
NOTE
The posts will not lift by unscrewing the post
covers. Only the motor can raise or lower the
posts.
POST GREASING PROCEDURE
1.
Lower the roof until it is fully closed.
2.
Remove rubber cap on top of each post see
Figure 86.
FIGURE 86: RUBBER CAP REMOVAL
3.
Dismount the screws (5) on the top plate of
the posts, see Figure 87.
4.
Remove the center screw. Keep the top
plates and the screws in a safe location see
Figure 87.
FIGURE 87: SCREW REMOVAL
5.
Repeat previous steps for all posts.
WARNING
Failure to remove all four top plates will result in
important damages to your cover.
Do not use power tools, since screws might break
or strip.
6.
Raise the jacks with the key switch. The four
internal jacks will raise but the cover panels
should stay in place, see Figure 88.
240799 OWNER'S MANUAL REVISION 4
To Next Page
Loading...