INSTALLATION MANUAL INSTALLATION 21
12) Pry off the three base plates of the crate using
your hand or a hammer if needed. (Figure 35)
CAUTION
Do not damage the components under the base
plates.
Flatten any protruding nails.
13) Remove the two I-Beams, the two long U-frame
pieces, the two short U-frame pieces and both
jacks located at the bottom of the crate. Lay
these parts down in a safe place. (Figure 36)
CAUTION
The small U-frames are nailed in; remove them
by hand to prevent any aesthetic damage.
Dropping the crate could damage the cover.
14) If your Covana cover was delivered with roller
shades, remove the cardboard cylinders from
the holes in the side panels and place them in a
safe place.
To Next Page
