3. Extracting hot water
Bell: sounds “ding.”
Flashes at an interval of 700ms during extraction.
Flsahes at an interval of 100ms from 1.4 seconds before
completing extraction.
Bell: sounds “ding.”
A
set quantity extraction
Stays On during extraction.
Flsahes at an interval of
100ms from 1.4 seconds
before completing extraction.
Extraction switch should be re-entered (150ms) or it goes
of
f after a specified time.
When the re-enter switch is of
f, the extraction is
recognized after 500ms.
Continuous extraction
Flashes at an interval of
1 second during extraction.
Flsahes at an interval of 100ms
from 1.4 seconds before
completing extraction.
Extraction switch should be re-entered (150ms) or it goes
of
f after extracting water for 60 seconds.
If ther is no additional extraction for 5 seconds after the
extraction, it switches to cold water mode.
Extracton switch
(Effective sensing time 100ms)
Extracton switch
(Effective sensing time 2000ms)
Bell:
sounds “ding” at the
beginning.
Bell sounds
“ding ding”
after 2 seconds.
Cold water selection switch is on
and the LED is on.
(Ef
fective sensing time 100ms)
Flashes at an interval of 1000ms during extraction.
Flsahes at an interval of 100ms 1.4 seconds before
completing extraction.
To Next Page
Loading...
