Need help?Do you have a question about the Craftex B2397 and is the answer not in the manual?
Detailed steps for performing rip cuts safely and effectively.
How to perform rip cuts with the blade set at an angle.
Safety considerations and methods for ripping narrow or small workpieces.
Instructions for performing cross cuts using the miter gauge.
Performing cross cuts with the blade set at an angle.
Cross cutting with the miter gauge set to an angle other than zero.
Combines bevel and miter cuts; instructions refer to previous sections.
How to keep the rip fence sliding smoothly and correctly.
Illustrates wiring configurations for 120V and 240V power supplies.
Procedures for returning, repairing, or replacing Craftex products.
To Next Page
General
