19
MAINTENANCE AND LUBRICATION
Proper care and maintenance should be give to your B2397 to ensure a longer life.
Use only mild soap and a damp cloth the clean to the tool. Do not allow liquid to enter the machine.
Do not immerse any part of the table saw in liquid.
Keep the table surface free of rust. If you notice rust spots after some time, treat them immediately.
To lubricate the saw, first use a stiff brush to clean any dust and debris from the gears and worms.
Remove and pitch or resin that has accumulated. Use a light solvent if necessary. Apply grease to the
gears. Paste wax can be used if the grease is attracting too much dust. Keep all spray lubricants
away from the upper guard. After long term use, the saw table mechanisms may require lubrication.
For maximum safety and reliability, major repairs and maintenance should be performed at an
authorized service center.
MAINTANING THE RIP FENCE
The rip fence should always slide freely. If it requires excessive force to slide it, or if it feels rough,
wipe the rails and fence head gliding surface with a cloth. Check the movement again. If it is still
rough, clean the fence head with a mild solvent. Coat the rail with a heavy coat of paste wax or a light
oil. Slide the fence back and forth several times to coat the rail and fence. Wipe off any excess wax or
oil from the rail. If the fence still does not move freely, adjust the fence tension.
To Next Page
Loading...
Need help?
General
