14
MAKING A PUSH STICK
In order to operate your table saw safely, you must use a push stick whenever the size o
shape of the work piece will cause your hands to be within 6” of the saw blade. Make sure the
push stick is long and sturdy enough to apply a noticeable amount of pressure.
A length of 14” is recommended with a notch that fits against the edge of the work piece to
prevent slipping. It is a good idea to have several push sticks of the same length (14”) with
different sized notches for work pieces of different thickness.
Below is a sample pattern of a typical push stick. The shape will vary depending on your
needs/requirements. The main purpose of the push stick is to keep your hands away from the
blade. Making the push stick out of hardwood or plywood is ideal. Ensure that it is less than or
equal to the width of the work piece to be cut.
To Next Page
Loading...
Need help?
General
